All Outputs (105)

Lattice Boltzmann simulation of free-surface temperature dispersion in shallow water flows. (2009)
Journal Article
Seaid, M., & Thömmes, G. (2009). Lattice Boltzmann simulation of free-surface temperature dispersion in shallow water flows. Advances in applied mathematics and mechanics, 1(3), 415-437

We develop a lattice Boltzmann method for modeling free-surface temperature dispersion in the shallow water flows. The governing equations are derived from the incompressible Navier-Stokes equations with assumptions of shallow water flows including b... Read More about Lattice Boltzmann simulation of free-surface temperature dispersion in shallow water flows..

Trigeneration running with raw jatropha oil (2009)
Journal Article
Wang, Y., Huang, Y., Roskilly, A. P., Ding, Y., & Hewitt, N. (2010). Trigeneration running with raw jatropha oil. Fuel Processing Technology, 91(3), 348-353. https://doi.org/10.1016/j.fuproc.2009.11.006

The performance and the efficiency of a trigeneration system fueling with pure diesel and with raw jatropha oil are investigated using the ECLIPSE software. The study is based on a diesel engine generating set. The genset is used for electrical power... Read More about Trigeneration running with raw jatropha oil.

Electrical response of highly ordered organic thin film metal-insulator-semiconductor devices (2009)
Journal Article
Ullah, M., Taylor, D. M., Schwödiauer, R., Sitter, H., Bauer, S., Sariciftci, N. S., & Singh, T. B. (2009). Electrical response of highly ordered organic thin film metal-insulator-semiconductor devices. Journal of Applied Physics, 106(11), Article 114505. https://doi.org/10.1063/1.3267045

We report a detailed investigation of the electrical properties of organic field-effect transistors (OFETs) and metal-insulator-semiconductor (MIS) capacitors formed from highly ordered thin films of C60C60 as the active semiconductor and divinyltetr... Read More about Electrical response of highly ordered organic thin film metal-insulator-semiconductor devices.

Reliability of wind turbine subassemblies (2009)
Journal Article
Spinato, F., Tavner, P., van Bussel, G., & Koutoulakos, E. (2009). Reliability of wind turbine subassemblies. IET Renewable Power Generation, 3(4), 387-401. https://doi.org/10.1049/iet-rpg.2008.0060

We have investigated the reliability of more than 6000 modern onshore wind turbines and their subassemblies in Denmark and Germany over 11 years and particularly changes in reliability of generators, gearboxes and converters in a subset of 650 turbin... Read More about Reliability of wind turbine subassemblies.

On the Measurement of Water Pressure in Soils with High Suction Tensiometers (2009)
Journal Article
Lourenço, S., Gallipoli, D., Toll, D., & Evans, F. (2009). On the Measurement of Water Pressure in Soils with High Suction Tensiometers. Geotechnical Testing Journal, 32(6), 565-57. https://doi.org/10.1520/gtj102372

HyperMacs to HyperBlocks: A Novel Class of Branched Thermoplastic Elastomer (2009)
Journal Article
Hutchings, L., Dodds, J., Rees, D., Kimani, S., Wu, J., & Smith, E. (2009). HyperMacs to HyperBlocks: A Novel Class of Branched Thermoplastic Elastomer. Macromolecules, 42(22), 8675-8687. https://doi.org/10.1021/ma901819f

We demonstrate here the great versatility of the macromonomer approach for the synthesis of long chain hyperbranched polymers (HyperMacs) and describe the synthesis of HyperMacs from polybutadiene and poly(methyl methacrylate) using analogous yet mod... Read More about HyperMacs to HyperBlocks: A Novel Class of Branched Thermoplastic Elastomer.

Correlation of friction measurements with wear characteristics during multi-station hip simulator wear tests (2009)
Presentation / Conference Contribution
Weisenburger, J., Naylor, M., Schroeder, D., White, B., Unsworth, A., Garvin, K., & Haider, H. (2009, October). Correlation of friction measurements with wear characteristics during multi-station hip simulator wear tests. Presented at 22nd Annual Congress of ISTA, Hawaii

2D lumped parameter model of axial flux permanent magnet generator: investiagations of convective thermal circuits (2009)
Presentation / Conference Contribution
Lim, C., Airoldi, G., Bumby, J., Dominy, R., Ingram, G., Mahkamov, K., Brown, N., Mebarki, A., & Shannel, M. (2009, October). 2D lumped parameter model of axial flux permanent magnet generator: investiagations of convective thermal circuits. Presented at International Conference on Computer, Electrical, and Systems Science, and Engineering, Venice, Italy

Air flow and heat transfer modeling of an axial flux permanent magnet generator (2009)
Presentation / Conference Contribution
Airoldi, G., Bumby, J., Dominy, R., Ingram, G., Lim, C., Mahkamov, K., Brown, N., Mebarki, A., & Shannel, M. (2009, October). Air flow and heat transfer modeling of an axial flux permanent magnet generator. Presented at International Conference on Computer, Electrical, and Systems Science, and Engineering, Venice, Italy

Biotribological and structural characteristics of 38 mm ZTA ceramic versus as-cast CoCrMo hip bearings. (2009)
Presentation / Conference Contribution
Williams, S., Wu, J., Unsworth, A., & Khan, I. (2009, October). Biotribological and structural characteristics of 38 mm ZTA ceramic versus as-cast CoCrMo hip bearings

Particle debris analysis and biological response of Motis acetabular cup wear debris over a 25 million cycle simulator test (2009)
Presentation / Conference Contribution
Kinbrum, A., & Unsworth, A. (2009, October). Particle debris analysis and biological response of Motis acetabular cup wear debris over a 25 million cycle simulator test. Presented at 22nd Annual Congress of ISTA, Hawaii

The effect of third body alumina particles on the wear and surface topography of 38 mm ceramic on as-cast CoCrMo total hip replacements (2009)
Presentation / Conference Contribution
Williams, S., Wu, J., Khan, I., & Unsworth, A. (2009, October). The effect of third body alumina particles on the wear and surface topography of 38 mm ceramic on as-cast CoCrMo total hip replacements. Presented at 22nd Annual Congress of ISTA, Hawaii

Wideband MIMO channel characterisation in TV studios and inside buildings in the 2.2-2.5 GHz frequency band (2009)
Journal Article
Razavi-Ghods, N., & Salous, S. (2009). Wideband MIMO channel characterisation in TV studios and inside buildings in the 2.2-2.5 GHz frequency band. Radio Science, 44(5), 1-13. https://doi.org/10.1029/2008rs004095

Multiple input multiple output (MIMO) measurements were performed with a chirp sounder with a switched antenna array at the transmitter and eight parallel receiver channels with 96-MHz bandwidth at 2.25 GHz in TV studios and 240-MHz bandwidth at 2.38... Read More about Wideband MIMO channel characterisation in TV studios and inside buildings in the 2.2-2.5 GHz frequency band.

Biotribological and structural characteristics of 28 mm diameter ZTA-ZTA hip joints under standard and aggressive wear conditions using a ProSim hip simulator (2009)
Presentation / Conference Contribution
Giddings, D., Wu, J., Khan, I., & Unsworth, A. (2009, October). Biotribological and structural characteristics of 28 mm diameter ZTA-ZTA hip joints under standard and aggressive wear conditions using a ProSim hip simulator. Presented at Annual Congress ISTA, Hawaii

Low voltage microgripper for single cell manipulation (2009)
Presentation / Conference Contribution
Solano, B., Gallant, A., Greggains, G., Wood, D., & Herbert, M. (2009, September). Low voltage microgripper for single cell manipulation. Presented at 3rd International Conference on Smart Materials, Structures and Systems, Acireale, Italy

In this work, we present the characterisation of an electrothermally actuated microgripper that operates in both dry and liquid media, and shows improved performance versus existing devices. The microgripper, fabricated in a combination of polymeric... Read More about Low voltage microgripper for single cell manipulation.

Screening and selection of sites for CO2 sequestration based on pressure buildup (2009)
Journal Article
Mathias, S., Hardisty, P., Trudell, M., & Zimmerman, R. (2009). Screening and selection of sites for CO2 sequestration based on pressure buildup. International Journal of Greenhouse Gas Control, 3(5), 577-585. https://doi.org/10.1016/j.ijggc.2009.05.002

Developing a simulation approach to support sustainable remanufacturing planning and control (2009)
Presentation / Conference Contribution
Wang, Q. (2009, September). Developing a simulation approach to support sustainable remanufacturing planning and control. Presented at The 7th International Conference on Manufacturing Research, University of Warwick

Reliability of offshore turbines – identifying risks by onshore experience. (2009)
Presentation / Conference Contribution
Faulstich, S., Hahn, B., Lyding, P., & Tavner, P. (2009, September). Reliability of offshore turbines – identifying risks by onshore experience. Presented at European Offshore Wind Conference

Approximate Solutions for Pressure Buildup During CO2 Injection in Brine Aquifers (2009)
Journal Article
Mathias, S., Hardisty, P., Trudell, M., & Zimmerman, R. (2009). Approximate Solutions for Pressure Buildup During CO2 Injection in Brine Aquifers. Transport in Porous Media, 79(2), 265-284. https://doi.org/10.1007/s11242-008-9316-7

Influence of Lode Angle Dependency on the Critical State for Rotational Plasticity (2009)
Presentation / Conference Contribution
Coombs, W., Crouch, R., & Augarde, C. (2009, September). Influence of Lode Angle Dependency on the Critical State for Rotational Plasticity. Presented at Computational Plasticity X: Fundamentals and Applications (COMPLAS X), Barcelona, Spain

The critical state in soils represents the condition whereby unbounded distortions occur with no change in volume. Many constitutive models incorporate this idealised asymptotic state as a fundamental feature. It has been shown experimentally that bo... Read More about Influence of Lode Angle Dependency on the Critical State for Rotational Plasticity.