Yvonne T. Spychala
The influence of basin setting and turbidity current properties on the dimensions of submarine lobe elements
Spychala, Yvonne T.; Eggenhuisen, Joris T.; Tilston, Mike; Pohl, Florian
Authors
Joris T. Eggenhuisen
Mike Tilston
Florian Pohl
Abstract
Submarine lobes have been identified within various deep‐water settings, including the basin‐floor, the base of slope and the continental slope. Their dimensions and geometries are postulated to be controlled by the topographic configuration of the seabed, sediment supply system and slope gradient. Ten experiments were conducted in a three‐dimensional‐flume to study the depositional characteristics of submarine lobes associated with: (i) different basin floor gradients (0 to 4°); (ii) different sediment concentrations of the parent turbidity current (11 to 19% vol); and (iii) varying discharge (25 to 40 m3 h−1). Most runs produced lobate deposits that onlapped onto the lower slope. Deposit length was proportional to basin‐floor angle and sediment volume concentration. A higher amount of bypass is observed in the proximal area as the basin‐floor angles get steeper and sediment concentrations higher. Deposits of runs with lower discharge could be traced higher upslope while runs with higher discharge produced an area of low deposition behind the channel mouth, i.e. discharge controlled whether lobe deposits were attached or detached from their channel‐levée systems. A particle‐advection‐length scale analysis suggests that this approach can be used as a first order estimation of lobe element length. However, the estimations strongly depend on the average grain size used for calculations (for example, silt is still actively transported after all sand has been deposited) and the method cannot be used to locate the main depocentre. Furthermore, attempted reconstructions of turbidity current velocities from natural systems suggest that the method is not appropriate for use in inversions from more complex composite bodies such as lobes.
Citation
Spychala, Y. T., Eggenhuisen, J. T., Tilston, M., & Pohl, F. (2020). The influence of basin setting and turbidity current properties on the dimensions of submarine lobe elements. Sedimentology, 67(7), 3471-3491. https://doi.org/10.1111/sed.12751
Journal Article Type | Article |
---|---|
Acceptance Date | Apr 14, 2020 |
Online Publication Date | May 29, 2020 |
Publication Date | 2020-12 |
Deposit Date | Jun 16, 2020 |
Publicly Available Date | May 29, 2021 |
Journal | Sedimentology |
Electronic ISSN | 1365-3091 |
Publisher | Wiley |
Peer Reviewed | Peer Reviewed |
Volume | 67 |
Issue | 7 |
Pages | 3471-3491 |
DOI | https://doi.org/10.1111/sed.12751 |
Public URL | https://durham-repository.worktribe.com/output/1262664 |
Files
Accepted Journal Article
(5.7 Mb)
PDF
Copyright Statement
This is the peer reviewed version of the following article: Spychala, Yvonne T., Eggenhuisen, Joris T., Tilston, Mike & Pohl, Florian (2020). The influence of basin setting and turbidity current properties on the dimensions of submarine lobe elements. Sedimentology 67(7): 3471-3491 which has been published in final form at https://doi.org/10.1111/sed.12751. This article may be used for non-commercial purposes in accordance with Wiley Terms and Conditions for Use of Self-Archived Versions.
You might also like
Transport and Burial of Microplastics in Deep-Marine Sediments by Turbidity Currents
(2020)
Journal Article
The influence of a slope break on turbidite deposits: An experimental investigation
(2020)
Journal Article
New flow relaxation mechanism explains scour fields at the end of submarine channels
(2019)
Journal Article